p20 tool steel
AISI P-20 Steel AISI P20 Prehardened is a chrome-moly tool steel made specifically to fill the requirements for the machined cavities and forces used in zinc die casting and plastic molding. It is delivered fully quenched and tempered to approximately Brinell 300. Other hardness levels may be obtained through additional heat treatment.
AISI P20 Steel Round Bar Sheet Plate, DIN 1.2311, SCM4. P20 steel round bar sheet plate has many excellent properties. In the pre-hardened status, the mold can be processed without any heat treatment. Which cut down the running period and improves efficiency. After it has been processed through the forged, 1.2311 steel becomes dense. AISI P20 Tool Steel - Waldun SteelAISI P20 Tool Steel. AISI P20 tool steel Manufacturer and Exporter,supplied with round,square,flat,block,and shaft etc.AISI P20 is a Cr-Mo alloyed steel as per ASTM A681.It is generally supplied in the hardened and tempered condition with hardness 285-340 HBW.Compared with P20+S(1.2312), it has good polishing and texturing properties,good machinability,and uniform hardness.
P20 P20 Physical Properties Tensile strength 115-234 b/MPa Yield Strength 23 0.2 /MPa Elongation 65 5 (%) - (%) Akv - Akv/J HBS 123-321 - HRC 30 - P20 Mechanical Properties Tensile strength 231-231 b/MPa Yield Strength 154 0.2 /MPa Tel:+86-80247006 Email:[email protected] https://steel-grades Mold Steel Products - Tool Steel - P20 - P20 High Hard (HH)P20 P20 High Hard . P20 Mold Steel. P20 is a low-alloy tool steel typically used for plastic injection mold cavities and die casting dies. P20 is typically sold in a pre-hard condition with a 28-32 on the Rockwell C Scale. P20 High Hard (HH) Mold Steel (A.K.A. P20HH) P20 high hard is an improved P20 with a 34-38 on the Rockwell C Scale.
P20 is an alloy tool steel which offers good machine ability even in the hardened and tempered (Brinell 300) condition. This steel gives an excellent polished finish and is one of the most widely accepted specifications for machine cut plastic molds and casting dies. P20 is often supplied in the hardened and tempered condition ready for machining. P20 Steel P20 Steel Plate - Engineering MaterialsTool Steel. P20 a versatile steel commonly used in the production of large mould frames & bolsters. Characterised by good toughness at moderate strength levels, P20 tool steel is a highly versatile engineering material. The alloy is a pre-hardened plastic mould steel and provides unified hardness across wide sections.
P20 tool steel stockholders and suppliers, delivering to the whole of the UK. West Yorkshire Steel are stockholders and suppliers of P20 tool steel round bar, flat bar and plate. P20 is an alloy tool steel which offers good machineability even in the hardened and tempered (Brinell 300) condition. High Speed Steel Tool Steel P20 Mold Steel P20P20 Mold Steel. P20 Mold Steel is a versatile, low-alloy tool steel that is characterized by good toughness at moderate strength levels. The steel is commonly used for plastic injection mold cavities and tooling and for die casting dies for zinc. P20 is typically sold in the pre-hardened condition at a hardness of approximately 300 HBW.